Micro Pro FLEX Flex Mount

This is the base flexible mount without the Extended Rosette Mount from the Micro Pro FLEX upgrade kit.

Designed specifically for Motorbikes for adhesive rear mounting to capture Rollers, and it can be used in many other places due to its flexibility.

The newly improved Flexible Adhesive base mount was designed specifically for use on curved or flat surfaces on the rear of motorbikes, where you need a much stronger mount than what a typical GoPro Mount will provide. It can also be used in any number of places where you need a good solid mount.

Note: Some items pictured are not included with the Micro Pro FLEX Mount. Please refer to the "What's in the box?" section below to see what is included. 

What's in the box?

• Flexible Adhesive Mount 
• Two 1/4" rubber washers
  
• Two male-to-male 1/4-20's
  
• Two Alcohol Swabs for preparing the surface
  
• Instructions
  

Specs

Weight: 90g

Adhesive mount length and width: 125mm x 85mm (5in x 3.4in)

Note: It is possible to cut the adhesive mount down slightly to fit, but please keep it at or outside the minimum trim size: 

Warranty: 12 months